BIQU MKS TMC2100 Stepper Motor Driver Board Ultra-quiet Drive with Heat Sink for Arduino 3D Printer

$12.98

(as of 04/05/2017 at 15:51 UTC)

Description

Specifications:
-Net Weight: 10g/pcs
-Pros: Super quiet
-Drive current algorithm: i = Vref * 1.9 / 2.5, the default Vref about 0.65v, so the default current is 0.5A, maximum current is1A
-When measuring voltage must not be connected to the motor, otherwise it will easy to burn drive
-When measuring voltage power, do not just connect the USB power supply
-When measuring voltage must not be connected to the motor, otherwise easy to burn drive
-Note: Adjust the potentiometer with a special ceramic screwdriver. Otherwise, the drive is easy to be damaged
-The heat sink on the drive block is stuck to the middle of the chip (the other driver is the same), otherwise, it is liable to be shortened in current with the next pin.
Package Included:
1* TMC2100 Stepper Motor Driver with HeatSink

Features

  • Higher operating temperature, it is 0.5A operating temperature of about 70 degrees and 1A working temperature exceeds 150 degrees without the addition of the fan case, it is possible to lose steps, the best operating current around 0.5A
  • Used on Ramps1.4 or MKS Gen, need to remove the 3 jumpers under the jack
  • Fins directly attached to the PCB
  • Motor direction and a4988 and drv8825 contrary, if you want to replace the a4988 direct, adjust firmware or adjust the motor wiring
  • Please pay special attention to the direction, do not inserted backwards

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

The owner of this website is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon properties including, but not limited to, amazon.com, endless.com, myhabit.com, smallparts.com, or amazonwireless.com.
Home Privacy Policy Terms Of Use Affiliate Disclosure DMCA Earnings Disclaimer